您好,歡迎訪問廣西重工液壓升降設備廠官網!
1、升降舞臺http://m.8kvv.com/用電阻檔檢查時,需要把電源斷開,然后通過電路原理圖進行測量,根據測量出的電阻值的大小,來對故障點進行分析。
When the landing stage with resistance profile check, you need to power off, then measured by the circuit diagram, according to the size of the measured resistance value, to analyze the fault.
2、用短路的方法檢查升降舞臺http://m.8kvv.com/時,可以以升降舞臺的控制原理圖為依據,對可能出現的故障觸點、開關等進行短接,短接后,如果故障消除了,就說明故障在這部分,縮小范圍后,再進行檢查,就可知道故障點。
When the landing stage, the stage can lift control schematics basis for possible fault contacts, switches, etc. shorting method to check short circuit shorted, if the fault is eliminated, it shows the fault in this section, narrow range, then check, you can know the point of failure.
公司名稱:廣西重工液壓升降設備廠
聯(lián)系人:鄭經理
手機號:18878881055
座機:0771-3366627
郵箱:584649766@qq.com
地址:廣西南寧市青秀區(qū)仙葫經濟開發(fā)區(qū)開天路23號
手機移動端
微信掃一掃