升降貨梯發動機機油壓力過低怎么辦？

升降貨梯機油的壓力低于0.2Mpa或隨發動機轉速變化而忽高忽低，甚至突然降至零位，此時應立即停機查找原因，待排除故障后方可繼續工作，否則會釀成燒瓦、拉缸等大事故。在發動機使用過程中，必須對機油的壓力給予高度重視。若機油油量不足，會使機油泵的泵油量減少或因進空氣而泵不上油，致使機油壓力下降，曲軸與軸承、缸套與活塞都會因潤滑不良而加劇磨損。

1、每班工作前檢查升降貨梯http://m.8kvv.com/油底殼中的油位，保證有足夠的油量。
Class work before checking cargo lifter oil level in the sump to ensure there is enough fuel.

2、應清除升降貨梯冷卻系統管路中的水垢，調整供油時間。
Should be cleared cargo lifter cooling system piping in scale, adjust injection timing.

3、讓升降貨梯http://m.8kvv.com/發動機在額定負荷下工作，當機油泵泵軸與襯套之間的間隙、齒輪端面與泵蓋的間隙、齒側間隙或徑向間隙因磨損而超過允許值時，都會導致泵油量減少，造成潤滑壓力下降的后果，應及時更換超差的機件。
Let cargo lifter engine at rated load of work, when the gap between the oil pump shaft and the bushing, the gap with the pump gear end cap, backlash or radial clearance exceeds the allowable value due to wear and will lead to pump oil

reduced, the pressure drop of lubricating consequences, should be replaced tolerance of parts.